-40%
3X VOCO SOLOBOND M Light Cure One Component Dentine & Enamel Bond 4ml Bottle

3X VOCO SOLOBOND M Light Cure One Component Dentine & Enamel Bond 4ml Bottle

$ 61.65

Availability: 70 in stock
  • Model: VOCO SOLOBOND M Light Cure One
  • Condition: New
  • Intended Use/Discipline: Dentistry
  • Brand: VOCO

    Description

    DESCRIPTION
    Solobond M:
    Light-curing universal one component dentine/enamel bonding agent
    INDICATION:
    Direct restoration of all cavity classes with all light-curing restoratives in total-etch technique
    One component – one application
    Excellent adhesion
    High material elasticity and permanently tight margins
    “Stick-immediately-effect” for easy application of the restorative
    Universal for all light-curing restoratives
    Application:
    The adhesive bond within the total-etch technique is achieved as follows:
    1. Drying Due to the subsequent application of light-curing restorative material, it is necessary to dry the tooth surface. Avoid any contamination of the cavity with blood or saliva. The use of a rubber dam is recommended.
    2. Preparation Prepare the cavity according to the principles of the adhesive restoration technique. Areas close to the pulp should be protected with a suitable calcium hydroxide based liner.
    3. Etching of enamel margins Etch entire cavity with etching gel (Vococid) starting from the enamel margin (enamel: approx. 20 - 30 s, dentine: 15 s maximum). Remove etching gel by suction, rinse for approx. 20 s and remove excess moisture with an air blower. Do not overdry dentine. The surface should remain slightly moist. The etched enamel should have a chalk-white/matt appearance. If not, repeat etching.
    4. Solobond M dispensing Dispense Solobond M onto a Micro Tim or a disposable brush. As an alternative, dispense Solobond M onto a mixing pallet.
    5. Solobond M application Apply Solobond M homogeneously to all prepared enamel and dentine surfaces with Micro Tim or a disposable brush and allow to act for 30 s. Then disperse Solobond M with a faint air jet and polymerise with LED/halogen light for 20 s. Do not remove or contaminate the inhibition layer since it is important for the adhesion to the composite.
    6.Work the filling material.
    DISCLAIMER
    The sale of this item may be subject to regulation by the U.S. Food and Drug Administration and state and local regulatory agencies. If so, please not bid on this item unless you are an authorized purchaser. If the item is subject to FDA regulation, I will verify your status as an authorized purchaser of this item before shipping of the item